I’ve been busy over the last 2 weeks creating a DIY camera dolly to make a short video for the ColorFabb Time-Lapse Contest 2015. There were some issues with the dolly though, most of which are related to the resolution for the pan and tilt movements. I had the components directly on the stepper motor shafts, but even with microsteps it just wasn’t enough to do several frames per layer. Should I attempt this again, I will need to look into gearing.
All motors and electronics have been moved to the new frame. Running the first test with auto bed leveling. So far it all seems good. Now to design the connector circuit board so that I can run all wires properly, but can still swap hotends easily.